Product Specification-HUITEX

Properties	Test Method	H2E200	H2E250	H2E300	H2E400	H2E500
Density, g/cm3	ASTM D792	0.94
Thickness, mm	ASTM D5199	2.0	2.5	3.0	4.0	5.0
Tensile Properties Strength at Yield, MPa Strength at Break, MPa Elongation at Yield,% Elongation at Break,%	ASTM D6693 Type IV Dumbbell G.L.=33mm G.L.=50mm	15 27 12 500
Pull-out Strength, Ton/m²		70
Carbon black Content,%	ASTM D1603	2-3
Carbon Black Dispersion	ASTM D5596	Category 1 or 2
Standard OIT, mins	ASTM D3895	100
ESCR(NCTL), hours	ASTM D5397	500
Water Absorption, %	ASTM D570	0.05
Width (Max.), m		3.0
Length, m		70	70	70	60	50

The thickness of HUITEX K-Liner ranges from 2.0 mm to 5.0 mm (excl. knobs)

All values are nominal test results, except as minimum or maximum when specified.

This specification is intended as guides only and is not intended as a warranty or guarantee. Huikwang Corporation assumes no liability in connection with the use of this information. Huikwang Corporation reserves the right to change the specification contained herein without notice.

If you don't find information you need, please send request to geo@huitex.com.

Ver. 12: 2022

Please download datasheet for HUITEX products below.

HDPE ENHANCED SMOOTH

HDPE ENHANCED SINGLE SIDE TEXTURED

HDPE ENHANCED DOUBLE SIDE TEXTURED

HDPE ENHANCED CONDUCTIVE SMOOTH

If you don't find the datasheet you need, please send request to geo@huitex.com.

Please download datasheet for HUITEX products below.

HDPE Welding Rod

LLDPE Weldig Rod

E-LOCK